Most important thing to keep in mind is that we put a coating of uniform thickness over the complete length of the rod. So, the part of the rod with the smallest diameter sets the coating thickness for the rest of the rod.
Important checkpoints
- Is the diameter within the prescribed tolerance over the full coating length?
- What is the cylindricity? Check smallest and biggest diameter over one circumference. Always mark any deviation.
- No dents allowed. If there are any don’t try to hide them but mark them and inform us about place and depth.
- Special attention for support lanes and grooves
We can correct a lot of pre-machining mistakes. Better of course is not to make them but if they are there, inform us so we are prepared.
Request we contact you
Thank you! Your submission has been received!
Oops! Something went wrong while submitting the form.
Request Quotation
Fill out the form to request a quote.
Request a quoteProduct data sheets
Get access to our download center
Get accessThank you! Your submission has been received!
Oops! Something went wrong while submitting the form.